How thick should concrete be for a 2 post car lift?

As for thickness, non-reinforced pavement four inches thick is standard for passenger car driveways. For heavier vehicles, a thickness of five inches is recommended. To eliminate standing water, the driveway should be sloped towards the street a minimum of one percent, or 1/8 inch per foot, for proper drainage.

3500 PSIBase Material Many basketball courts are built over a 4” thick concrete slab using 3500 PSI concrete and 1/2″ rebar reinforcements. Concrete is considered ideal for basketball courts as a permanent structure that when done right will not require any maintenance.

12,000 pound two-post lifts (and higher capacity): Six (6) inches of concrete at 3000 PSI is required.

100mmThe minimum and recommended thicknesses of concrete slab for car hoists. Garage Equipment's two and four post hoists require a minimum of 100mm (about 4”) of reinforced concrete slab to be safely installed.

about 4 inchesConcrete Slab The base of reinforced concrete should be about 4 inches thick and be able to withstand a weight of at least 115 pounds per square foot, especially for larger spas. The concrete should be fully cured prior to placing the tub.

The Thickness Of Concrete Planters For Durability The thickness of a planter needs to be a minimum of ⅜” thick.

To calculate how much concrete you need, you need to know the post size you are going to use and how many posts you are installing.

Your post diameter and height determine how big each hole needs to be.

As stated above, fence post holes should be 3 times the diameter of your post and 1⁄3 as deep as your post..

Make sure your desired mailbox post meets Federal Highway administration recommendations: a stable post that can bend or fall to the side if hit by a car. Avoid unyielding supports such as metal or concrete posts, and instead use a 4 x 4-inch wooden support or a 2-inch diameter standard steel or aluminum pipe.

four-inchesThe concrete slab should be four-inches thick at least; it needs to be thicker if heavy equipment will rest on it.

The general rule of thumb when setting a post is that the depth of the post's hole needs to be 1/3 to 1/2 of the actual above-ground height of the post. So, six-foot-high fence posts ideally need to be buried three feet into the ground. The diameter of your post hole should be three times the diameter of your post.

The depth of the hole should be 1/3-1/4 the post height above ground (i.e., a 6-foot tall would require a hole depth of at least 2 feet).

Remember, the depth of the post hole should be one-half of the above-ground post height.

(Example: For a 6 feet above ground post, use a post with an overall height of 9 feet and place 3 feet in the ground).

The calculator will indicate the number of 50 lb.

bags of QUIKRETE® Fast-Setting Concrete you need..

The general rule of thumb when setting a post is that the depth of the post's hole needs to be 1/3 to 1/2 of the actual above-ground height of the post. So, six-foot-high fence posts ideally need to be buried three feet into the ground.

4 inchesHere are our tips for making sure your installation is an uplifting experience.

Some of manufacturers standards for a 2-Post and 4-Post Lifts require a minimum 4 inches of reinforced concrete slab to be safely installed..

The optimal size for a fire pit is between 36 and 44 inches inside diameter. That will create enough room for a healthy fire but still keep gatherers close enough to chat. As an added precaution, the fire pit should be lined with a thick steel ring like the ones used for park campfires.

A solid base with good concrete at 4” should support an average forklift.

4 inchesHere are our tips for making sure your installation is an uplifting experience. Some of manufacturers standards for a 2-Post and 4-Post Lifts require a minimum 4 inches of reinforced concrete slab to be safely installed.

1/2 inchUnlike other cement products, it is designed to be applied in very thin coats (no more than 1/2 inch thick), and its additives provide good adhesion to an existing slab. Concrete resurfacer is a very strong product, rated for a compressive strength of about 4,500 psi.

four inchesAs for thickness, non-reinforced pavement four inches thick is standard for passenger car driveways. For heavier vehicles, a thickness of five inches is recommended. To eliminate standing water, the driveway should be sloped towards the street a minimum of one percent, or 1/8 inch per foot, for proper drainage.

A deck post should always be placed on top of footing, not inside concrete because it can break. The photo on the left shows a post set in a bracket that has been mounted to the top of a footer. ... When concrete is poured around a deck post in this way, the post will rot due to moisture buildup by the soil.

Cement or concrete overlay thicknesses can range from 1/4 inch thick up to a full 2 inches or more..

Four inches is the minimum thickness for a concrete patio. You'll want to make it six to eight inches thick if the patio will support a structure such as a gazebo or hot tub.

Advised drying time An example: for a 6 cm thick concrete floor, you should count on at least (4 x 1 week) + (2 x 2 weeks) = 8 weeks of drying time. For concrete floors thicker than 6 cm, respect 4 weeks of drying time per additional cm.

4 inchesAs a general rule, you should not make a concrete deck less than 4 inches thick. This depth will keep the deck strong enough to withstand general wear and tear. You could choose to make the deck 6 inches thick for good results.

600mmConcrete fence posts must be fixed into the ground in the traditional way: by digging a hole.

When concreting fence posts into the ground, the posts should be buried a minimum of 600mm deep.

The recommended depth for a 1.80m or 6 foot high fence is 760mm or 2' 6"..

For domestic mixes – driveways, for example – you can expect the concrete to be set within 24-48 hours.

But again, you should give it the full 28 days before using it to park the family car..

To calculate how much concrete you need, you need to know the post size you are going to use and how many posts you are installing. Your post diameter and height determine how big each hole needs to be. As stated above, fence post holes should be 3 times the diameter of your post and 1⁄3 as deep as your post.

Also 1-1/2 bags per hole is about right for a 4x4 fence post. Also remember, the depth of the post hole should be one-half of the above-ground post height. (Example: For a 6' above ground post, use a post with an overall height of 9 feet and place 3 feet in the ground).

To calculate how much concrete you need, you need to know the post size you are going to use and how many posts you are installing. Your post diameter and height determine how big each hole needs to be. As stated above, fence post holes should be 3 times the diameter of your post and 1⁄3 as deep as your post.

For domestic mixes – driveways, for example – you can expect the concrete to be set within 24-48 hours. But again, you should give it the full 28 days before using it to park the family car.

Walls: Use 1/2-inch or 5/8-inch-thick cement board, not 1/4-inch.

The extra thickness is needed to span the studs and provide a solid base for the tile..

25 to 50 mmThe minimum recommended thickness is 1 to 2 in. (25 to 50 mm) for a fully bonded concrete overlay placed on a base slab that is practically free of cracks and in which the concrete is sound, clean, and of good quality.

The minimum thickness advised for many levelling compounds is only 2 or 3 millimetres (some require a minimum of 5mm).

QUIKRETE® Fast-Setting Self-Leveling Floor Resurfacer (No. 1249-51) can be installed from 1-1/2 inch (38 mm) thick to a feather edge, although a ¼ inch (6.3 mm) minimum thickness is required for heavy traffic areas.

For domestic mixes – driveways, for example – you can expect the concrete to be set within 24-48 hours. But again, you should give it the full 28 days before using it to park the family car.

Project InstructionsDig post hole so diameter of the hole is 3 times the width of the post (i.e., the hole for a 4” wood post should be about 12 inches wide).

...

Add about 6 inches of QUIKRETE All-Purpose Gravel into the bottom of the hole.

...

Set the post into the hole and attach 2x4 braces to adjacent sides of the post.More items....

3-5 feetCement blocks are built in piers (think mini-towers–but they don't lean) 3-5 feet apart. If the sheds are built like they should be, the structure of the shed easily spans the piers–unless you're parking the car in it, in which case you'll want to consider a gravel pad.

Usually, expansion joints should be no farther apart than 2 to 3 times (in feet) the total width of the concrete (in inches). So for a 4 inch thick concrete slab, expansion joints should be no more than 8 to 12 feet apart.

The size of a typical driveway in the UK ranges from about 5.5m2 for a 1 car space up to 21m2 for a good–sized 2 car space. The average cost of a laying a concrete driveway lies somewhere around £50/m2 with labour costing between £200 and £450 per day depending on the complexity of the work.

A typical residential patio is 4″ thick with an average of 3000 pounds per square inch ratio. It is designed to carry more than the weight of two automobiles. The average compact car is about 3,000 to 3,500 lbs. A mid size car, van or light truck is about 5,000 to 7,000 lbs.

75-100mmConcrete paths should be 75-100mm thick, whereas drives, garage bases or hardstandings should be at least 100mm thick. For heavier use, such as large vans, use a 150-200mm thick concrete slab.

100 mmHow thick should a concrete driveway be laid to.

A minimum of 100 mm is recommended.

Thickness is a major factor in determining the driveway's structural capacity..

Standard Thickness The standard concrete garage floor is six inches thick and, with use of proper control joints, should be thick enough to withstand normal use.

Thickness for Concrete Shower Pan – Base Layer The shower pan base mortar layer thickness should be approximately ½ to 1 inch thick. Since the shower floor already has a pre-slope, just apply a base mortar layer that has an even thickness throughout the shower floor area.

Therefore I recommend that all the walls should be at least 9 inch thick. 4.5-inch thick walls are not structurally safe if they are beyond 7 feet in height or carry some imposed load.

1 - 4 bagsWhen you're installing a fence post, the amount of concrete you need will be calculated based on the diameter of your fence post and how high the post is above ground. Most fence post holes will need between 1 - 4 bags of concrete to securely hold the post in place.

For example: A 6' high fence post 4"x4" needs a hole 12" in diameter by about 2' to 3' deep. That would take four 50 lb. bags of fast setting concrete mix per fence post.

The general rule of thumb when setting a post is that the depth of the post's hole needs to be 1/3 to 1/2 of the actual above-ground height of the post. So, six-foot-high fence posts ideally need to be buried three feet into the ground. The diameter of your post hole should be three times the diameter of your post.

four inches thickAs for thickness, non-reinforced pavement four inches thick is standard for passenger car driveways. For heavier vehicles, a thickness of five inches is recommended. To eliminate standing water, the driveway should be sloped towards the street a minimum of one percent, or 1/8 inch per foot, for proper drainage.

Drill 2-inch holes into the sunken concrete and pour a mixture of fly ash, sand, water, and cement into the holes with a pump that produces 50 to 100 pounds of pressure. The mixture, which is like thick mortar, easily raises the sunken slab.