Do I need council approval for a concrete slab?

A 60-pound bag yields . 017 cubic yards, and an 80-pound bag yields . 022 cubic yards. For a 10 x 10 slab, you would need 77 60-pound bags or 60 80-pound bags.

Unlike self-drilling screws which do not need pilot holes due to their drill bit end, self-tapping screws like concrete screws do require the user to mark a spot for the pilot hole.

For a 10 x 10 slab, we'd suggest a mix with a capacity of about 4,000 pounds per square inch, or psi. This is basic for residential projects, and it can withstand traffic and support heavy loads.

As I recall, a 60# bag of concrete is about .

5cf, so you'd need 3 bags per hole..

How many concrete bags would I need for a 8 ft x 8 ft x 6" slab? 54 x 80lb Concrete bags. How much does it cost to pour a 8'x8' x6" slab? Ready-mix costs approx $277.86.

22.222 cu. yds. How many concrete bags would I need for a 30 ft x 40 ft x 6" slab?

With a brief look, a 16x16 area at 6 inches deep, you would need approximately 6.73 tons or 4.74 cubic yards of gravel. Concrete reinforcing is also recommended in high traffic areas and medium to large areas.

You do not need rebar for any slab if you make it thick enough and space the joints properly. Rebar in jointed pavement is there to counter the cupping effect of thermal expansion. I always recommend the use of rebar or at least rewire. Any concrete slab can crack.

All 3 types of slabs will need a footer and a slab of at least 4″ thick. The footers depth needs to be the depth of the frost line or as per local code, but no less than 12″ deep. ... Slab Foundations Like all foundations, the slab starts with concrete footers poured 24 inches below projected finish grade.

Rebar in patios, basement floors, footings and driveways may vary from size 3 to 6. Contractors sometimes use the “1/8 Rule,” meaning the size of the rebar is 1/8 the thickness of the slab. For example, a slab that is 6 inches thick might have rebar marked as size 6 or 3/4-inch.

With a brief look, a 20x20 area at 6 inches deep, you would need approximately 10.52 tons or 7.41 cubic yards of gravel. Concrete reinforcing is also recommended in high traffic areas and medium to large areas.

Joints should be sawed as soon as the concrete will withstand the energy of sawing without raveling or dislodging aggregate particles. ... Contraction/control joints must be established to a depth of ¼ the slab thickness (Figure 2). Proper joint spacing and depth are essential to effective control of random cracking.

Concrete is strong in compression, but not under tension. So, if it flexes, like a slab with a vehicle on top of will do, it cracks at the bottom whre the flexing becomes tension. ... Mesh will help mitigate the chances of cracking of the slab due to differential settlement.

Do concrete patios need rebar? Even though it's possible to build a concrete patio without rebar, it's not recommended. All concrete is subject to cracks, but rebar holds all the cracks together and keeps the slab level and even. Without rebar, the cracks would become quite wide and the concrete would become uneven.

Rebar is recommended for concrete that measures 5-6 inches in depth. The type of and intended use of concrete impacts the need for rebar reinforcement. Rebar must be placed at the center of or slightly above the center of the concrete slab—hence why it should be a certain thickness for best results.

You can concrete ove an easement providing you get approval from the appropriate authorities (ie who owns the services). Although it rarely happens, just remember that they have the right to remove anything built over the easement if they need to work on the services.

In general, if you are doing any work which is going to modify your floor plan, then, you do need a permit. If you are going to pour concrete for a patio in your backyard, then, yes, you do need a permit.

Average Cost To Pour Concrete To pour a typical 10x10 concrete slab will cost $670 to $930, a 12x12 slab for a patio will cost $796 to $1,476, a 20x24 driveway slab runs between $1,440 and $3,360, and a 24x24 slab for a garage will cost $3,058 to $5,944.

Table and chairs for up to eight requires a minimum 12' x 12' concrete slab. Small end tables and chairs do vary on size of the table. For concrete purposes we generally recommend 5' x 5' concrete slab. Tanning lounger/ Chaise loungers need a minimum of 8' of concrete off of the swimming pool.

How many concrete bags would I need for a 5 ft x 5 ft x 6" slab? 20.8 x 80lb Concrete bags.

You will need 45 bags of concrete mix to make a cubic yard of concrete.

For example, a sono tube with a 10" diameter and a 4' depth requires 0.08 cubic yards of concrete.

10 x 10 = 100 square feet. 4 ÷ 12 = .33. 100 x .33 = 33 cubic feet. 33 x .037 = 1.22 cubic yards.

Your project is 32 square feet at a depth of 4”. Here is the quantity that you will need for your slab. Quikrete Concrete Mix: 24- 60lb bags.

You really do not want the patio level with the house threshold, too easy for water to get in to the house. As for the slab, it will not settle if you prepare the subgrade correctly. You need the footers to support the structure, the slab is just there to walk on, and has no structural importance.

All concrete will shrink slightly as it dries and, when it's set, will expand or contract depending on the ambient temperature. To prevent cracks from forming, concrete expansion joints should be incorporated to allow for movement, particularly in slabs with a surface area exceeding 6m2.

“The minimum depth of sawcut using a wet conventional saw should be the greater of at least 1/4 of the slab depth or 1 in. (25 mm). The minimum depth of sawcut using an early-entry dry-cut saw should be 1 in. ... Some slab designers require cutting the slab the following day to 1/4 of the slab depth to deepen the 1 in.

For a concrete patio slab the best method of providing reinforcement is to use either wire mesh or steel bars (rebar) placed in a grid pattern. The use of rebar requires that each of the intersections of rebar be tied together with rebar tie wire. ... This must be done as soon as the concrete is poured.

For a 10 x 10 slab, you would need 77 60-pound bags or 60 80-pound bags. If we add an extra 10%, that's an extra 8 60-pound bags or 6 80-pound bags.

Excavate the slab area to a depth of about 7 inches, allowing 3 inches for a gravel base and 4 inches for concrete.

Really depends on what the slab is used for but in general no you can install wire mesh or use fibered concrete. However you do need something to tie the concrete it just doesn't have to be rebar. You do not need rebar for any slab if you make it thick enough and space the joints properly. ... Any concrete slab can crack.

While not a requirement, a concrete slab foundation provides a solid, clean surface for your steel building and can help it last longer. Since the building will require anchoring to minimize shifting, pouring a concrete slab gives you a chance to pour footings as well.

Enter the size of the slab you want to build in square feet. The calculator will indicate the number of 60 or 80 pound bags of QUIKRETE® Concrete Mix you need to build a 4″ or a 6″ slab. (All yields are approximate and do not include allowance for uneven subgrade, waste, etc.)

You can concrete ove an easement providing you get approval from the appropriate authorities (ie who owns the services). Although it rarely happens, just remember that they have the right to remove anything built over the easement if they need to work on the services.

Whether you pour concrete for a walkway or patio, a strong gravel base is required to prevent the concrete from cracking and shifting.

Gravel is especially important in clay soil because it doesn't drain well, which results in water pooling under the concrete slab and slowly eroding the soil as it finally drains..

Each 80-pound bag of QUIKRETE(r) Concrete Mix will yield approximately 0.6 cubic feet of concrete. For a 10' by 10' slab at 4" thick, you will need 33-1/3 cubic feet of concrete, or 56 80-pound bags. Yields are approximate and will vary with waste, uneven subgrade, etc.

Using a Concrete Calculator You'll also get the number of 40-pound, 60-pound, or 80-pound bags of concrete are needed for the project. For example, a 10′ x 10′ slab that is 4″ thick will need an estimated 1.23 yards3 or 75 60lb bags of concrete and will cost roughly $140.

The volume of concrete required for a 10- by 10-foot slab depends on the diameter of the slab.

For a 4-inch slab, either eight 60-pound or six 80-pound bags are required, while for a 6-inch slab, either 12 60-pound or nine 80-pound bags are necessary..

The volume of concrete required for a 10- by 10-foot slab depends on the diameter of the slab. For a 4-inch slab, either eight 60-pound or six 80-pound bags are required, while for a 6-inch slab, either 12 60-pound or nine 80-pound bags are necessary.

Here is the quantity that you will need for your slab. Quikrete Concrete Mix: 24- 60lb bags.

Concrete Slab Prices By SizeSlab SizeSquare FeetAverage Cost Installed15x15225$1,38820x20400$2,46824x24576$3,55420x30600$3,7026 more rows

They are 4 feet in height and 10 inches in width (diameter), or 4′ x 10″.Choose Round Column (or Round Slab) on the calculator.Enter Height 4 ft (or 48 in)Enter Diameter 10 in.Calculate and the answer is 0.08 cubic yards for one concrete tube.Multiply 0.08 x 50 = 4 total cubic yards of concrete for 50 tubes.More items...

For example, a sono tube with a 10" diameter and a 4' depth requires 0.08 cubic yards of concrete.

You do need gravel under a concrete slab, footing, or patio. Gravel provides a solid foundation for your concrete as it can be compacted. It also improves drainage, preventing water from pooling beneath the concrete.

No, they do not. Larger projects or slabs may need steel reinforcement to provide support or extra strength. Wired mesh can also help resist cracking. However, not every piece of concrete necessarily requires that extra boost.

If a slab is installed on a subbase that is of high quality and that offers uniform support, it is usually not necessary to reinforce the concrete.

However, if the subbase is problematic or the spacings of the joints are greater than 15 feet, reinforcement should be used..

All three types of slabs will need a footer and a slab of at least 4″ thick. The footer's depth needs to be the frost line's depth or as per local code, but no less than 12″ deep.

Hot tubs do not have to sit on concrete. They can be placed on wooden decks, paver stones, gravel beds, or spa pads. Just don't place a hot tub directly on the ground or on a wooden deck that was not built to support the weight of a fully-loaded hot tub.

Do I need a concrete slab for a Tuff Shed storage building? No, in most cases. While garages do require a concrete slab, our exclusive steel joist system has more than adequate strength and moisture resistant qualities to provide a solid foundation for your shed on most ground surfaces.

Yes, you will be required to pull a permit when removing a tree, including dead trees. Do I need to obtain a permit to pour a concrete slab, patio, or driveway? Yes, a site plan will be required with a description of what is being done.